 |
» |
|
|
|
|
|
|
|
|
HP EliteBook 2760p Tablet PC - Removing and Replacing the Hard Disk Drive
Introduction
This document is provided to assist in removing and replacing the hard disk drive for the HP EliteBook 2760p Tablet PC.
Minimum skill level
The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.
Tools required
Small, Phillips-head P1 screwdriver
Parts required
|
NOTE:
|
Part numbers are subject to change. |
| Description
|
Part Number
|
Requires Return
|
|---|
| 320GB, 7200 rpm, SATA 7 mm (2.5 in), self-encrypting drive (SED) |
656621-001 (Modified) |
Yes |
| 320GB, 7200 rpm, SATA 7 mm (2.5 in) |
656620-001 (Modified) |
Yes |
| 250GB, 7200 rpm, SATA 7 mm (2.5 in) |
656619-001 (Modified) |
Yes |
| 128GB solid-state drive |
653017-001 (Modified) |
Yes |
| 160GB solid-state drive |
653018-001 (Modified) |
Yes |
|
NOTE:
|
For customers in countries/regions with RoHS legislation* (e.g. EU,
China, etc.) restricting the use of hazardous substances in electrical
equipment.
The use of the Original Spare part is regulated by RoHS legislation. If your
unit contains a part that is labelled with the Modified Spare number, the
Modified Spare must be ordered as the replacement part.
If your unit contains a part that is labelled with the Original Spare number,
please order the Original Spare as the replacement part. In this case either
the Original Spare or the Modified Spare may be shipped which will not
affect performance or functionality of the unit. |
Summary of instructions
To view a video demonstrating the procedure for removing the hard disk drive, click on the link below. Or use the product video listing on the HP Services Media Library,
(Click here to go to HP Service Media Library)
, then select Hard disk drive
from the menu on the upper left hand side of the screen. Hard disk drive removal
Review the safety considerations before performing the steps listed below by clicking on the following link:
| CAUTION:
|
Failure to comply with the precautions
could result in damage to your product or loss of data.Observe all precautions when removing and replacing components. |
-
-
Remove the 3-mm P1 Phillips-head screw that secures the hard disk drive to the base enclosure.
Loosen the captive P1 Phillips-head screw that secures the hard disk drive to the base enclosure.
Grasp the Mylar tab and slide the hard disk drive toward the front of the tablet to disconnect it from the system board.
Lift the hard disk drive and carrier out of the base enclosure.
Remove the four 3-mm P1 Phillips-head screws that secure the hard disk drive carrier to the hard disk drive.
Lift and remove the hard disk drive from the hard disk drive carrier.
Place the hard disk drive in a static dissipative bag.
Hard disk drive replacement
Remove the hard disk drive from the static dissipative bag.
Place the hard disk drive on to the hard disk drive carrier.
Replace the four 3-mm P1 Phillips-head screws to secure the hard disk drive to the hard disk drive carrier.
Place the hard disk drive into the hard disk drive bay.
Grasp the Mylar tab and slide the hard drive toward the rear of the tablet until it is fully seated into its connector on the system board.
Tighten the captive P1 Phillips-head screw to secure the hard disk drive to the base enclosure.
Replace the 3-mm P1 Phillips-head screw to secure the hard disk drive to the base enclosure.
-
-
Parts return
If your part requires return then click on the appropriate link below:
|
|
Printable version
