 |
» |
|
|
|
|
|
|
|
|
HP Compaq nc6400 Notebook PC - Removing and Replacing the Optical Drive
Introduction
This document is provided to assist in removing and replacing the Optical Drive for the HP Compaq nc6400 Notebook PC.
Minimum skill level
The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.
Parts required
|
NOTE:
|
Part numbers are subject to change. |
| Description
|
Part Number
|
Requires Return
|
|---|
| DVD±RW and CD-RW Double-Layer Combo Drive |
418866-001 |
Yes |
|
DVD±RW and CD-RW Combo Drive |
418865-001 |
Yes |
|
DVD-ROM drive |
418864-001 |
Yes |
|
NOTE:
|
For customers in countries/regions with RoHS legislation* (e.g. EU,
China, etc.) restricting the use of hazardous substances in electrical
equipment.
The use of the Original Spare part is regulated by RoHS legislation. If your
unit contains a part that is labeled with the Modified Spare number, the
Modified Spare must be ordered as the replacement part.
If your unit contains a part that is labeled with the Original Spare number,
please order the Original Spare as the replacement part. In this case either
the Original Spare or the Modified Spare may be shipped which will not
affect performance or functionality of the unit. |
Summary of instructions
To view a video demonstrating the procedure for removing the Optical Drive, click on the link below. Or use the product video listing on the
HP Services Media Library
, then select Optical Drive
from the menu on the upper left hand side of the screen. Optical Drive removal
Review the safety considerations before performing the steps listed below by clicking on the following link:
| CAUTION:
|
Failure to comply with the precautions
could result in damage to your product or loss of data. |
-
Remove the 4 mm P0 Phillips-head screw that secures the optical drive to the base enclosure.
|
NOTE:
|
Screw location is indicated by the appropriate icon.
|
Press and release the eject icon on the end of the optical drive front bezel to partially eject the optical drive.
Grasp the sides and pull the optical drive out of the base enclosure.
Optical Drive replacement
Insert the optical drive into the base enclosure until the connector is seated.
Replace the 4 mm P0 Phillips-head screw that secures the optical drive to the base enclosure.
-
Parts return
If your part requires return then click on the appropriate link below:
|
|
Printable version
