 |
» |
|
|
|
|
|
|
|
|
HP 2140 Fax - Replacing the Cartridge
Introduction
This document contains steps for installing a replacement cartridge in the product. Before you perform the following steps, make sure the replacement cartridge is compatible with your product.
| Cartridge
|
Description
|
Part number
|
|---|
Image of HP 701 Ink Cartridge packaging |
| Black
|
HP 701 Black Inkjet Cartridge |
CC635A |
Replacing ink cartridges
Follow these steps to replace the cartridge in the product.
Step one: Open the product
Press the Access Cartridge
button on the product control panel. The carriage moves to the access position.
Open the control panel, and then the cartridge compartment cover.
Figure 1: Open access doors
1 - Open control panel
2 - Open cartridge compartment
illustration of opening control panel, and then cartridge compartment cover
Step two: Replace the old cartridge
Push down on the cartridge to release it from the carriage, and then lift it up and out of the product.
Figure 2: Remove the old cartridge
illustration of removing the old cartridge Remove the new cartridge from its packaging, and then pull the pink tab to remove the clear protective tape.
Figure 3: Prepare new cartridge
illustration of preparing a new cartridge | CAUTION:
|
Do not touch the copper-colored contacts or re-tape the cartridge. |
Figure 4: Do not touch contacts
warning not to touch the cartridge contacts Hold the cartridge with the label on top.
Figure 5: Label on top
illustration of holding the cartridge with label on top With the copper-colored contacts facing into the carriage, insert the cartridge into the carriage at upward angle. Push the cartridge up, and then into the carriage until it snaps into place.
Figure 6: Install cartridge
1 - Insert cartridge
2 - Push cartridge up
3 - Push cartridge in
illustration of install the cartridge |
NOTE:
|
If the cartridge moves loosely in the carriage, it has not clicked into place. Repeat this step. |
Close the cartridge compartment cover, and then the control panel.
Step three: Align the cartridge
Press the Start
button ( 
) on the product control panel. Press 1
to indicate you installed a new cartridge.
The product prints an alignment page and 06 [01-11]
displays on the control panel.
Figure 7: Alignment page prints
illustration of alignment page printing Review the alignment page, and then select the number under the straightest line.
Press that number on the keypad, and then press the OK
button ( 
).
|
|
Printable version
