 |
» |
|
|
|
|
|
|
|
|
HP ProBook 4525s Notebook PC - Removing and Replacing the Hard Disk Drive
Introduction
This document is provided to assist in removing and replacing the hard disk drive for the HP ProBook 4525s Notebook PC.
Minimum skill level
The End-User should possess product-specific knowledge and technical skill on how to service the system, and have familiarity with the operating system.
Parts required
|
NOTE:
|
Part numbers are subject to change. |
| Description
|
Part Number
|
Requires Return
|
|---|
| DRV HDD 500GB 7200 RPM |
616288-001(Original)
|
Yes |
| DRV HDD 320GB 7200 RPM |
616287-001(Original) |
Yes |
| DRV HDD 250GB 7200 RPM |
616286-001(Original) |
Yes |
|
NOTE:
|
For customers in countries/regions with RoHS legislation* (e.g. EU,
China, etc.) restricting the use of hazardous substances in electrical
equipment.
The use of the Original Spare part is regulated by RoHS legislation. If your
unit contains a part that is labelled with the Modified Spare number, the
Modified Spare must be ordered as the replacement part.
If your unit contains a part that is labelled with the Original Spare number,
please order the Original Spare as the replacement part. In this case either
the Original Spare or the Modified Spare may be shipped which will not
affect performance or functionality of the unit. |
Summary of instructions
To view a video demonstrating the procedure for removing the hard disk drive, click on the link below. Or use the product video listing on the HP Services Media Library,
Click here to go to HP Services Media Library
, then select Hard disk drive
from the menu on the upper left hand side of the screen. Hard disk drive removal
Review the safety considerations before performing the steps listed below by clicking on the following link:
| CAUTION:
|
Failure to comply with the precautions
could result in damage to your product or loss of data. |
-
-
-
-
Remove the two 5 mm P1 Phillips-head screws from the left side of the hard disk drive bracket.
Loosen the captive P1 Phillips-head screw on the right side of the hard disk drive bracket.
Use the black Mylar tab located on the hard disk drive enclosure to slide the hard disk drive away from the hard disk drive connector on the system board.
Remove the hard disk drive from the hard disk drive bay.
|
NOTE:
|
If necessary, remove the hard disk drive from the hard disk drive bracket by removing four 4 mm P1 Phillips-head screws, and reuse the hard disk drive bracket with the replacement hard disk drive.
|
Place the hard disk drive in an electrostatic dissipative bag.
Hard disk drive replacement
Remove the hard disk drive from the electrostatic dissipative bag.
Place the hard disk drive into the hard disk drive bay and align it with the hard disk drive connector on the system board.
Use the black Mylar tab located on the hard disk drive enclosure to slide the hard disk drive securely onto the hard disk drive connector.
Tighten the captive P1 Phillips-head screw on the right side of the hard disk drive bracket.
Replace the two 5 mm P1 Phillips-head screws on the left side of the hard disk drive bracket.
-
-
-
-
Parts return
If your part requires return then click on the appropriate link below:
|
|
Printable version
