 |
» |
|
|
|
|
|
|
|
|
HP ProBook 4510s Notebook PC - Removing and Replacing the Bluetooth Module
Introduction
This document is provided to assist in removing and replacing the Bluetooth Module for the HP ProBook 4510s Notebook PC.
Minimum skill level
The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.
Parts required
|
NOTE:
|
Part numbers are subject to change. |
| Description
|
Part Number
|
Requires Return
|
|---|
|
Integrated wireless Bluetooth 2.0 module |
483113-001 |
Yes |
|
NOTE:
|
For customers in countries/regions with RoHS legislation* (e.g. EU,
China, etc.) restricting the use of hazardous substances in electrical
equipment.
The use of the Original Spare part is regulated by RoHS legislation. If your
unit contains a part that is labelled with the Modified Spare number, the
Modified Spare must be ordered as the replacement part.
If your unit contains a part that is labelled with the Original Spare number,
please order the Original Spare as the replacement part. In this case either
the Original Spare or the Modified Spare may be shipped which will not
affect performance or functionality of the unit. |
Summary of instructions
To view a video demonstrating the procedure for removing the Bluetooth Module, click on the link below. Or use the product video listing on the
HP Services Media Library
, then select Bluetooth Module
from the menu on the upper left hand side of the screen. Bluetooth Module removal
Review the safety considerations before performing the steps listed below by clicking on the following link:
| CAUTION:
|
Failure to comply with the precautions
could result in damage to your product or loss of data. |
| CAUTION:
|
Observe all precautions when removing and replacing components. |
Remove the battery, switch cover, keyboard, palm rest, and hard disk drive.
Disconnect the Bluetooth cable from its connector on the right side of the system board.
Remove the tape that secures the Bluetooth cable to the base enclosure.
Remove the bluetooth cable from its routing channel on the base enclosure and top cover.
Release the right side of the Bluetooth module from its clip on the top cover.
Remove the top left corner of the Bluetooth module from its alignment slot on the top cover.
Remove the Bluetooth module from the base enclosure and place it in an electrostatic dissipating bag.
Bluetooth Module replacement
Remove the Bluetooth module from the electrostatic dissipating bag.
Toe the top left corner of the Bluetooth module into its alignment slot on the top cover.
Secure the Bluetooth module into its clip on the top cover.
Route the Bluetooth cable through its routing channel on the top cover and base enclosure.
Replace the tape that secures the Bluetooth cable to the base enclosure.
Connect the Bluetooth cable into its connector on the right side of the system board.
Parts return
If your part requires return then click on the appropriate link below:
|
|
Printable version
