 |
» |
|
|
|
|
|
|
|
|
HP Deskjet D4360, D4363, and D4368 Printers - Setting Up the Product (Hardware)
Introduction
This document explains how to set up the physical parts of the product. Complete these steps before
you install the product software on your computer. If you already set up the product hardware, and need software installation help, see Links to Software Installation Instructions
at the end of this document. Follow these steps in order. When you are finished, you can click the appropriate link at the end of this document if you need instructions to install the product software.
| CAUTION:
|
Do NOT connect the USB cable now. If you need a USB cable to connect the product to the computer, you will be prompted to connect it at the correct time during software installation. |
Step one: Unpack the product
Remove all the tape and orange packing material from the product.
Figure 1: Remove tape and packing material
Remove tape and packing material Lower the paper tray.
Figure 2: Lower the paper tray
Lower the paper tray Open the cover and remove the packing material from the inside of the product.
Figure 3: Open the cover and remove the packing material
Open the cover and remove the packing material Close the cover.
Figure 4: Close the cover
Close the cover
Step two: Connect the power cord and adapter
Connect the power supply to the back of the product.
Connect the power cord to the power supply.
Connect the power cord to an electrical outlet.
Figure 5: Connect the power cord and adapter
1 - Connect the power supply to the product.
2 - Connect the power cord to the adapter.
3 - Connect the power cord to an electrical outlet.
Connect the power cord and adapter
Step three: Turn on power
Press the Power button ( 
) to turn the product on. Figure 6: Power button location on the product
Power button location on the product
Step four: Load plain paper
Raise the output tray.
Figure 7: Raise the output tray
Raise the output tray Slide the paper width guide to the left, and then load a stack of plain paper in the input tray.
Figure 8: Adjust the paper guide and load paper
Adjust the paper guide and load paper Slide the paper width guide to the right until it rests firmly against the paper.
Lower the output tray, and then pull out the tray extension.
Figure 9: Pull out the tray extension
Pull out the tray extension
Step five: Install the cartridges
|
NOTE:
|
The exterior of the product varies by model. The product might not match the product in the animation, but the procedure is the same. |
Open the cover.
Figure 10: Open the cover
Open the cover Wait until the carriage moves to the right side of the product and is idle.
Remove the cartridge from its packaging, and then pull the pink tab to remove the tape from the cartridge.
Figure 11: Remove the protective tape
Remove the protective tape | CAUTION:
|
Do not touch the ink nozzles and copper contacts on the cartridge. Touching these parts can result in clogs, ink failure, and bad electrical connections. Do not remove the copper strips. They are required electrical contacts. |
Figure 12: Do not touch the ink nozzles or copper contacts on the cartridge
1 - Ink nozzles
2 - Copper contacts
Do not touch the ink nozzles or copper contacts on the cartridge Hold the cartridge so that the copper strips are on the bottom and
facing toward the product.
Slide the cartridge at a slight upward angle into the carriage until the cartridge
snaps into place.
Figure 13: Insert the cartridge
Insert the cartridge Close the cover.
Figure 14: Close the cover
Close the cover
Links to software installation instructions
After you complete the previous setup steps, you can install the product software with the product CD or by downloading the software from the HP Web site. For instructions, click the link for your computer operating system and type of connection.
| CAUTION:
|
Do NOT connect a USB cable now. You will be prompted to connect it at the correct time during software installation. |
|
|
Printable version
