Overview
The HP DeskJet 350 series printer uses a Ni-MH battery. The battery is shipped in a discharge condition and must be fully charged before use. No external charger is needed to re-charge the battery pack due to the printer's built-in fast re-charger. The battery lasts approximately 30% longer than the Ni-Cad battery used by the HP DeskJet 340 series printer.
|
NOTE:
|
Use ONLY the Ni-MH battery pack (C3394A) designed specifically for use with the HP DeskJet 350 series printer. |
Installing the battery pack
Refer to the following illustrations in order to install the battery pack.
Figure 1: Remove the battery cover.
Figure 2: Align the charge terminals.
Figure 3: Insert the battery and slide it until it locks into place.
Figure 4: Attach the battery cover.
Removing the battery pack
Refer to the following illustrations to remove the battery pack.
Figure 5: Remove the battery cover.
Figure 6: Press down on the battery release lever and slide the battery toward the lever.
Charging the battery pack
To charge a battery pack, the battery pack must be installed in the printer and the printer must be connected to a proper power source. The printer does not need to be powered on in order to charge the battery pack. Use of the printer while the battery charges may increase the time required to fully re-charge the battery.
The first charge (from empty to full) requires approximately 1 hour and 40 minutes. Subsequent recharges will take slightly more than 1 hour. Do not use an external charger to recharge the battery pack. Use only the printer's built-in charger.
The battery can be charged within a temperature range of 0 degrees C (32 degrees F) to 40 degrees C (104 degrees F). The battery may be warm after charging or use. This is normal.
When a fully discharged battery is removed from the printer, set the charge condition indicator at the end of the battery so that the red dot is visible. This tells you the condition of the battery.
|
NOTE:
|
The Ni-MH battery is resistant to "Memory Effect" issues typically experienced by Ni-Cad batteries. Therefore, recharging the battery before it is empty will not affect its performance. |
To prevent damage to the
battery
Do not drop the
battery
or expose it to any other mechanical shock.
Use the
battery
only with the specified Hewlett-Packard printer.
Printable version
