 |
» |
|
|
|
|
|
|
|
|
Compaq Mini 102 - Removing and Replacing the Hard Disk Drive
Introduction
This document is provided to assist in removing and replacing the hard disk drive for the Compaq Mini 102.
Minimum skill level
The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.
Tools required
Small, Phillips-head (P000, P0 and P1) screwdrivers
Small, flat-bladed screwdriver or a flat-bladed alignment tool
Parts required
|
NOTE:
|
Part numbers are subject to change. |
| Description
|
Part Number
|
Requires Return
|
|---|
| 160GB SATA hard drive - 5,400 rpm, 9.5 mm, 2.5-inch form factor - Includes hard drive bracket |
594809-001 (Modified) |
Yes |
|
NOTE:
|
For customers in countries/regions with RoHS legislation* (e.g. EU,
China, etc.) restricting the use of hazardous substances in electrical
equipment.
The use of the Original Spare part is regulated by RoHS legislation. If your
unit contains a part that is labelled with the Modified Spare number, the
Modified Spare must be ordered as the replacement part.
If your unit contains a part that is labelled with the Original Spare number,
please order the Original Spare as the replacement part. In this case either
the Original Spare or the Modified Spare may be shipped which will not
affect performance or functionality of the unit. |
Summary of instructions
To view a video demonstrating the procedure for removing the hard disk drive, click on the link below. Or use the product video listing on the HP Services Media Library, (
Click here to go to HP Service Media Library
), then select Hard disk drive
from the menu on the upper left hand side of the screen. Hard disk drive removal
Review the safety considerations before performing the steps listed below by clicking on the following link:
| CAUTION:
|
Failure to comply with the precautions
could result in damage to your product or loss of data. |
-
-
-
Remove the two 3 mm P0 Phillips-head screws that secure the hard disk drive bracket to the notebook.
Loosen the captive P1 Phillips-head screw that secures the hard disk drive to the notebook.
Using the mylar tab, pull the hard disk drive to the left to disconnect it from the system board and remove the hard disk drive from the notebook.
Place the hard disk drive in a static dissipative bag.
Hard disk drive replacement
Remove the hard disk drive from the static dissipative bag.
Place the hard disk drive into the hard disk drive bay and slide the drive to the right to connect it to the system board.
Tighten the captive P1 Phillips-head screw that secures the hard disk drive to the notebook.
Replace the two 3 mm P0 Phillips-head screws that secure the hard disk drive to the notebook.
-
-
-
Parts return
If your part requires return then click on the appropriate link below:
|
|
Printable version
