 |
» |
|
|
|
|
|
|
|
|
HP EliteBook 8530p Notebook PC - Removing and Replacing the Bluetooth Module
Introduction
This document is provided to assist in removing and replacing the Bluetooth module for the HP EliteBook 8530p Notebook PC.
Minimum skill level
The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.
Tools required
P1 Phillips-head screwdriver
Parts required
|
NOTE:
|
Part numbers are subject to change. |
| Description
|
Part Number
|
Requires Return
|
|---|
| Embeded Broadcom Bluetooth module |
490809-001 (Modified) |
Yes |
|
NOTE:
|
For customers in countries/regions with RoHS legislation* (e.g. EU,
China, etc.) restricting the use of hazardous substances in electrical
equipment.
The use of the Original Spare part is regulated by RoHS legislation. If your
unit contains a part that is labelled with the Modified Spare number, the
Modified Spare must be ordered as the replacement part.
If your unit contains a part that is labelled with the Original Spare number,
please order the Original Spare as the replacement part. In this case either
the Original Spare or the Modified Spare may be shipped which will not
affect performance or functionality of the unit. |
Summary of instructions
To view a video demonstrating the procedure for removing the Bluetooth module, click on the link below. Or use the product video listing on the
HP Services Media Library
, then select Bluetooth module
from the menu on the upper left hand side of the screen. Bluetooth module removal
Review the safety considerations before performing the steps listed below by clicking on the following link:
| CAUTION:
|
Failure to comply with the precautions
could result in damage to your product or loss of data. |
-
Loosen the two captive P1 Phillips-head screws that secure the hard disk drive cover to the bottom of the notebook.
Use your finger or a flat-bladed tool to lift the inside edge of the hard disk drive cover and remove it.
Slide the Bluetooth module cover out of the base enclosure.
Remove the Bluetooth module from the slot in the cover.
Disconnect the Bluetooth module cable from the Bluetooth module.
Place the Bluetooth module in a static dissipative bag.
Bluetooth module replacement
Remove the Bluetooth module from the static dissipative bag.
Reconnect the Bluetooth module cable to the Bluetooth module.
Place the Bluetooth module into the slot in the cover.
Toe the Bluetooth module cover into the base enclosure and slide it into position until it clicks. Ensure the Bluetooth module cable remains inside the base enclosure.
Toe the hard disk drive cover into the enclosure.
Tighten the two captive P1 Phillips-head screws.
Parts return
If your part requires return then click on the appropriate link below:
|
|
Printable version
